illbruck FM610 Multi Handheld Foam 750 ml
Professional polyurethane foam suitable for sealing, insulating, and filling joints, seams, gaps, and cavities.
Number of | Price per piece |
---|---|
1x
|
€4.40 |
12x
|
€4.15 |
48x
|
€3.95 |
120x
|
€3.75 |
Order before 23:59, delivered next working day
Application
Suitable for sealing, insulating, and filling connections, joints, seams, and gaps of, among others: partition walls with ceilings, partition walls between each other, gaps between window or door frames and walls, assembly and installation spaces between prefab elements, connection joints of ridge beams, purlins, and dormers, pipe and conduit penetrations, and for bonding and sealing insulation boards.
Usage Tip
Observe overall work hygiene during application. Wear gloves and safety glasses. Remove cured foam mechanically only. Refer to the label on the packaging and/or the Safety Data Sheet for additional information.
Advantages
- Universally applicable
- Professional quality
- Resistant to heat, water, and many chemicals
- Paintable and can be finished with plaster
- Low post-expansion
- Very good acoustic properties
- Longer shelf life: 24 months
detail.eanLabel | 8713465281069 |
---|---|
Brand: | Illbruck |
Product Type: | Handschuim |
illbruck FM610 Multi Handheld Foam 750ml
Preparation
- Excellent adhesion to concrete, masonry, stone, plaster, wood, fiber cement, metal, and plastics such as polystyrene, PU foam, polyester, and rigid PVC.
- Surfaces must be dry, clean, and free of dust and grease.
- For best results, it is advisable to pre-moisten porous surfaces during dry periods.
Application
- Shake the can vigorously for at least 20 seconds with the protective cap in place before use.
- Remove the protective cap and screw the adapter with the hose onto the valve.
- Hold the can with the valve facing downwards.
- The foam quantity can be dosed by tilting the adapter.
- Fill for about 50% capacity.
- For joints wider than 30 mm and deeper than 70 mm, apply foam in multiple layers with intervals of approximately 1 - 2 hours. Lightly pre-moisten before applying the next layer.
- Shake the can regularly during use.
- If reusing the can, shake it again.
- FM610 is not suitable for fireproof sealing of joints and seams, for this purpose, use Nullifire FF197 Fireproof Foam.
Material
1-component polyurethane foam that hardens by absorbing moisture from the air. CFC-, HCFC-, and HFC-free (ozone-friendly and does not contribute to the greenhouse effect).
Recently viewed products
Professional polyurethane foam suitable for sealing, insulating, and filling joints, seams, gaps, and cavities.